Removing The Device Drivers; Installing Qlogic Management Applications; Viewing Or Changing The Adapter Properties - Qlogic FastLinQ 3400 Series User Manual

4–Windows Driver Software

Removing the Device Drivers

Removing the Device Drivers
Uninstall the QLogic 8400/3400 Series device drivers from your system only
through the InstallShield wizard. Uninstalling the device drivers with Device
Manager or any other means may not provide a clean uninstall and may cause the
system to become unstable.
NOTE
Windows Server 2008 and Windows Server 2008 R2 provide the Device
Driver Rollback feature to replace a device driver with one that was
previously installed. However, the complex software architecture of the
8400/3400 Series device may present problems if the rollback feature is
used on one of the individual components. Therefore, we recommend that
changes to driver versions be made only through the use of a driver installer.
To remove the device drivers, in Control Panel, double-click Add or Remove
Programs.

Installing QLogic Management Applications

1. Execute the setup file (setup.exe) to open the QLogic Management
Programs installation wizard.
2. Accept the terms of the license agreement, and then click Next.
3. In the Custom Setup dialog box, review the components to be installed,
make any necessary changes, and then click Next.
4. In the Ready to Install the Program dialog box, click Install to proceed with
the installation.

Viewing or Changing the Adapter Properties

To view or change the properties of the QLogic network adapter
1. Open the QCC GUI.
2. Click the Advanced section of the Configurations tab.
21 83840-546-00 E