Specifications; Qla2340/2340L Hba Operating Environment; Qla2340/2340L Hba Specifications - Qlogic SANblade 2300 Series User Manual


14. Create an alias entry for the new boot device (optional). For example:
ok nvalias fibredisk
/pci@1f,0/pci@1/QLGC,qla@4/sd@82,0
15. Set default boot device to be the new boot device (optional). For example:
ok setenv boot-disk fibredisk
2.5

Specifications

Tables 2-7 and 2-8
Table 2-7. QLA2340/2340L HBA Operating Environment
Environment
Operating temperature
Storage temperature
Relative humidity (noncondensing)
Storage humidity (noncondensing)
Table 2-8. QLA2340/2340L HBA Specifications
Type
Host bus Conforms to PCI Local Bus Specification, revision 2.2 and the PCI-X
Addendum, revision 1.0
PCI/PCI-X 3.3 V and 5.0 V buses supported
signaling
environment
PCI/PCI-X 132 MBps maximum burst rate for 32-bit PCI operation at 33 MHz
transfer rate
264 MBps maximum burst rate for 32-bit PCI/PCI-X operation at 66 MHz
264 MBps maximum burst rate for 64-bit PCI operation at 33 MHz
528 MBps maximum burst rate for 64-bit PCI/PCI-X operation at 66 MHz
1GBps maximum burst rate for 64-bit PCI-X operation at 133 MHz
Fibre Bus type: Multimode fibre optic media
Channel
Bus transfer rate: 200 MBps maximum at half-duplex
specifications
Interface chip: ISP2312
CPU Single-chip design that includes a QLogic RISC processor, Fibre Channel
protocol manager, PCI/PCI-X DMA controller, and integrated
serializer/deserializer (SERDES) and electrical transceivers that can
auto-negotiate a data rate of 1 Gbps or 2 Gbps
RAM 256 KB of sync SRAM supporting parity protection
BIOS ROM 128 KB of flash ROM in two 64-KB, software selectable banks. The flash
is field programmable.
FC2354601-00 A
define the QLA2340/2340L specifications.
400 MBps maximum at full-duplex
Minimum
0 C/32 F
-20 C/-4 F
10%
5%
Specification
2 – QLA2340/2340L
Specifications
Maximum
55 C/131 F
70 C/158 F
90%
95%
2-19