Qlogic FastLinQ 3400 Series User Manual page 169

9–Fibre Channel Over Ethernet
FCoE Boot from SAN
11. Repeat steps 8 through 10 for all initiator ports.
12. Confirm all FCoE visible disks are visible under Multipath Devices and/or
Other SAN Devices.
13. Click Next to proceed.
14. Click Next and complete installation as usual.
Upon completion of installation, the system will reboot.
15. Once booted, ensure all boot path devices are set to start on boot. Set
onboot=yes under each network interface config file in
/etc/sysconfig/network-scripts.
16. On RHEL 6.4 only, edit /boot/grub/menu.lst.
a.
b.
Delete all fcoe=<INTERFACE>:nodcb parameters from the kernel
/vmlinuz ... line. There should be as many fcoe= parameters as
there were FCoE interfaces configured during installation.
Insert fcoe=edd:nodcb to the kernel /vmlinuz ... line.
141 83840-546-00 E