Table of Contents
Advertisement
9–Fibre Channel Over Ethernet
FCoE Boot from SAN
6.
For each interface to be enabled for FCoE boot, click Change Settings and
ensure FCoE Enable and AUTO_VLAN are set to yes and DCB required is
set to no.
7.
For each interface to be enabled for FCoE boot, click on Create FCoE
VLAN Interface. The VLAN interface creation dialog will launch. Click Yes
to confirm. This will trigger automatic FIP VLAN discovery. If successful, the
VLAN will be displayed under FCoE VLAN Interface. If no VLAN is visible,
check your connectivity and switch configuration.
134
83840-546-00 E
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the FastLinQ 3400 Series and is the answer not in the manual?
Questions and answers