Qlogic FastLinQ 3400 Series User Manual page 116

8–iSCSI Protocol
iSCSI Boot
13. Change the grub menu to point to the new initrd image.
14. To enable CHAP, you need to modify iscsid.conf (Red Hat only).
15. Reboot and change CHAP parameters if desired.
16. Continue booting into the iSCSI Boot image and select one of the images
you created (non-offload or offload). Your choice should correspond with
your choice in the iSCSI Boot parameters section. If HBA Boot Mode was
enabled in the iSCSI Boot Parameters section, you have to boot the offload
image. SLES 10.x and SLES 11 do not support offload.
17. For IPv6, you can now change the IP address for both the initiator and the
target to the desired IPv6 address in the NVRAM configuration.
SUSE 11.1 Remote DVD installation workaround
1. Create a new file called boot.open-iscsi with the content shown below.
2. Copy the file you just created to /etc/init.d/ folder and overwrite the existing
one.
88 83840-546-00 E