User Diagnostics In Dos; Introduction; System Requirements - Qlogic FastLinQ 3400 Series User Manual

17

User Diagnostics in DOS






Introduction

QLogic 8400/3400 Series User Diagnostics is an MS-DOS based application that
runs a series of diagnostic tests (see
network adapters in your system. QLogic 8400/3400 Series User Diagnostics also
allows you to update device firmware and to view and change settings for
available adapter properties.
To run QLogic 8400/3400 Series User Diagnostics, create an MS-DOS 6.22
bootable disk containing the uediag.exe file. Next, start the system with the boot
disk in drive A. See
on running diagnostic tests on QLogic network adapters.

System Requirements

Operating System: MS-DOS 6.22
Software: uediag.exe
Introduction
System Requirements
Performing Diagnostics
Diagnostic Test Descriptions
"Performing Diagnostics" on page 240
Table 17-2) on the QLogic 8400/3400 Series
239
for further instructions
83840-546-00 E