Manually Extracting The Device Drivers - Qlogic FastLinQ 3400 Series User Manual

4–Windows Driver Software

Manually Extracting the Device Drivers

To perform a silent install from within the installer source folder
Type the following:
setup /s /v/qn
To perform a silent upgrade from within the installer source folder
Type the following:
setup /s /v/qn
To perform a silent reinstall of the same installer
Type the following:
setup /s /v"/qn REINSTALL=ALL"
NOTE
The REINSTALL switch should only be used if the same installer is already
installed on the system. If upgrading an earlier version of the installer, use
setup /s /v/qn as listed above.
To perform a silent install to force a downgrade (default is NO)
setup /s /v" /qn DOWNGRADE=Y"
Manually Extracting the Device Drivers
To manually extract the Windows device drivers, type the following
command:
setup /a
This will run the setup utility, extract the drivers, and place them in the designated
location.
20 83840-546-00 E