Setting Communication Without The Foma Pc Setup Software - Sony Ericsson FOMA SO905iCS Manual

Disconnecting Communication
Sometimes, closing the Inter net browser does
not disconnect communication. To ensure the
disconnection of communication, perform the following
procedure.
1
Click the dial-up icon in the task tray.
2
Select the currently active dial-up
connection and click [切断].
The connection is disconnected.
Host (APN) Setting
You can set a host (APN) for packet communication.
Connect the FOMA terminal to a PC before starting this
operation.
1
Start the FOMA PC setup software and click [接続
先(APN)設定].
2
Click [OK].
The host (APN) is loaded from the FOMA terminal. Wait for
a few moments.
3
Set a host (APN).
To add a host (APN)
Click [追加].
To edit (change) a host (APN)
Select a host (APN) and click [編集].
To delete a host (APN)
Select a host (APN) and click [削除].
 You cannot delete a host (APN) saved as [cid1] and
[cid3]. (Even if you select [cid3] and click [削除], it
is not actually deleted. The operation is returned to
[mopera.net].)
To save data in a file
Click the [ファイル] menu → [上書き保存]/[名前を付け
て保存].
To read data from a file
Click the [ファイル] menu → [開く] and select a saved
file.
To read host (APN) data from the FOMA terminal
Click the [ファイル] menu → [FOMA端末から設定を
取得].
To write host (APN) data to the FOMA terminal
Click the [ファイル] menu → [FOMA端末へ設定を書き
込む].
To create dial-up
Select a host (APN) and click [ダイヤルアップ作成]. Set
up a dial-up connection for packet communication in
accordance with the instructions on the window.
●
The host (APN) is information that must be saved in the
FOMA terminal. When you use the PC with a different
FOMA terminal connected, it is required to save it again in
the new FOMA terminal.
● To continue using a host (APN) saved in the PC, save the
registration number (cid) of the same host (APN) in the
FOMA terminal.
Setting Communication without
the FOMA PC Setup Software
Dial-up icon
The procedure for setting packet or 64K data
communication without using the FOMA PC setup
software is given below.
To perform the settings, communication software for
entering AT commands is necessary. In this section,
the "Hyper Terminal" preinstalled as a standard feature
in the Windows is used for explanation.
Host (APN) Setting
Set a host (APN) for performing packet communication.
 If you are using "mopera U" or "mopera" as the packet
communication host, you do not have to set a host for 64K
data communication.
Example: When using Windows XP
1
Connect the FOMA terminal to a PC.
2
Click [スタート] → [すべてのプログラム] → [アク
セサリ] → [通信] → [ハイパーターミナル].
Hyper Terminal is started up.
When using Windows 2000 Professional
C l i c k [ スタート] → [ プログラム] → [ アクセサリ] →
[通信] → [ハイパーターミナル].
When using Windows Vista
Windows Vista does not support Hyper Terminal. Perform
the same operations using other terminal software.
3
Enter any name at [名前] and click [OK].
18