Receiving A Message - Sony Ericsson FOMA SO905iCS Manual

Receiving a Message

When a message is received while in the
stand-by display, the contents of the message
are automatically displayed. Up to 20 Message
R and Message F each can be saved in the
FOMA terminal.
Ｒｅｃｅｉｖｉｎｇ
ＭｅｓｓａｇｅＲ
When receiving is completed, " "/" "/" " is
displayed, the indicator flashes, the ring tone
sounds, and the number of received messages is
displayed.
The contents of the message appear automatically
after about 15 seconds. The display before
receiving reappears after about 15 seconds when
no operations are made.
 Messages that are automatically displayed are
saved as unread.
● When the number of saved received messages
has reached 20 and a new message is received,
the unprotected message is overwritten from the
oldest.
● You can also disable Auto-display of messages
(P.230).
● Messages are held at the i-mode center when " ",
" ", " ", " ", " ", " ", " ", " ", or " " appears
(sometimes " ", " ", " ", " ", " ", " ", " ", " ", or
" " do not appear even if messages are held at
the i-mode center).
If the maximum number of messages is held
at the i-mode center, " ", " ", " ", " ", " ", " ",
" ", " ", " " appears. In this case, perform the
Check new message after checking contents
of the unread messages, delete unnecessary
m e s s a g e s , a n d c a n c e l p ro t e c t i o n o f t h e
messages.
230
<Receive message>
When receiving a message,
" "/" "/" " flashes.
● Message R/F that has been sent to you in the
following situations is held at the i-mode center.
- During a videophone call
- When the FOMA terminal is powered off
- When the FOMA terminal is outside of the
i-mode service area
- During PushTalk communication
- While receiving SMS
- While the Self mode is set
- While the Omakase Lock is set
- During the infrared communication
- During the iC communication
- While updating the software
- While connected to the FirstPass Center
- While connected to the Data Security Service
Center
Setting Auto-display
You can set to display the contents of the
message automatically when it is received
while in the stand-by display. You can also
select which message should be displayed
first when receiving both Message R and
Message F at the same time.
1
From the Mail menu, select [Mail setting]
→ [Common setting] → [Auto-display]
and press .
[Prefer msgR]:
Display automatically Message R first when
receiving Message R and Message F at the
same time.
[MessageR only]:
Display automatically Message R only.
[Prefer msgF]:
Display automatically Message F first when
receiving Message R and Message F at the
same time.
[MessageF only]:
Display automatically Message F only.
[Display off]:
Do not display automatically.
To set from the i-mode menu
From the i-mode menu, select [i-mode setting] →
[Common setting] → [Auto-display].
2
Select a display method and press
The Auto-display is set.
.