Setting The Date And Time - Sony Ericsson FOMA SO905iCS Manual

Setting the Date and Time

You can set the date and time either by automatically correcting the time based on
the time information obtained from the DoCoMo network or by manually setting the
time.
Example: Correcting the time automatically
1
From the Menu, select [Settings] → [Management] → [Date/time] and press
.
Ｄａｔｅ／ｔｉｍｅ
Ａｕｔｏ ｔｉｍｅ ａｄｊｕｓｔ
ＯＮ
Ｍａｎｕａｌ ｃｌｏｃｋ ｓｅｔ
2
Select [ON] at [Auto time adjust].
[ON] : Correct the date and time automatically.
[OFF] : Do not correct the date and time automatically. Set the time using the Manual clock
set.
To set the time manually
Select [Manual clock set] → [Yes] and enter the year and date within the range from
2000/01/01 to 2050/12/31, the time in 24-hour format (00:00 to 23:59), and select time
zone. Press
●
When you set the Auto time adjust to [ON], the date and time are corrected automatically
when the FOMA terminal is powered on with a UIM installed. Note, however, that there may
be an error lasting several seconds. The time cannot be automatically corrected in the
following cases.
- Outside of the service area (The time may not be corrected automatically even inside the
service area depending on the radio wave condition.)
- While i-αppli is running
● The date and time settings are retained even when you replace the battery pack. However,
if you leave the FOMA terminal without a battery pack or with a fully expended battery pack,
the date and time may be reset to "----/--/-- --- --:--". In this case, set the date and time once
again.
● If the date and time are not set, functions that use the clock, such as the current time icon,
Schedule, Alarm, i-αppli Auto-start, and calendar/clock display cannot be used. The date
and time for the Redial/Received record and the date and time on images shot with the
camera are also not recorded.
● When you receive time correction information from the network of the carrier to which the
FOMA terminal is connected during international roaming, the time is automatically corrected
when the Auto time adjust is set to [ON].
When the time is corrected to the local time, the date and time used for the Redial/Received
record and sent/received mail also are corrected to the local time and "
however, that some overseas networks may not perform time correction.
44
[Auto time adjust] : Set the time automatically.
[Manual clock set] : Enter the time manually. When you set the time
(Complete).
using the Manual clock set, the Auto time adjust is
set to [OFF].
<Date/time>
" appears. Note,