Sony Ericsson FOMA SO905iCS Manual page 438

※1 If you subscribe to the Call Waiting Service, you can place a call to another recipient while
you already have a call in progress.
※2 If you subscribe to the Call Waiting Service, you can receive another call while you already
have a call in progress. If you do not yet subscribe to the Call Waiting Service, you can
receive another call after you disconnect the first call.
※3
You can place a voice or videophone call or originate a PushTalk call after disconnecting
the current communication.
※4
The FOMA terminal does not perform the receiving operation and a received call is saved
in the Received record as a missed call.
※5 If you do not yet subscribe to the Voice Mail Service, Call Waiting Service, or Call
Forwarding Service, a received call is not saved in the Received record.
※6 In either of the following cases, the FOMA terminal notifies you of an incoming voice call
and you can select either to "answer a voice call" or to "continue with PushTalk call". (The
one that was not selected is terminated.)
 When the P-Talk arrival act is set to [Answer]
 When the P-Talk arrival act is set to [Voice Mail] or [Call Forwarding] and you do not
subscribe to these services
※7 If you originate a PushTalk call, you can place another call to add a member.
※8 The FOMA terminal performs the operation set by the V.ph while packet.
 When the V.ph while packet is set to [Prefer packet] or when the V.ph while packet is set
to [V.ph voicemail] or [Call forwarding] and you do not subscribe to these services, the
packet communication is continued.
 When the V.ph while packet is set to [Prefer V.phone], packet communication is
disconnected and you can receive a videophone call.
※9
The FOMA terminal performs the operation set by the i-mode arrival act.
 When set to [Prefer i-mode], i-mode communication is continued.
 When set to [Prefer PushTalk], i-mode communication is disconnected and you can
receive a PushTalk call.
※10 While you are performing i-mode communication using i-αppli, you can send data after
disconnecting the i-mode communication in progress.
※11 A combination of the same communication direction, either sending or receiving, is not
available.
※12 When you set the Host selection to [i-mode(UIM)], " " appears.
※13 After the current communication is terminated, the Full Browser communication is started.
※14 When switching from i-mode to Full Browser, after the i-mode communication is terminated,
the Full Browser communication is started.
※15 You can only place a call by entering a phone number directly in the stand-by display.
436