Sony Ericsson FOMA SO905iCS Manual page 205

When You Receive i-Channel
→ 最高１０℃ １０
Telop
When you receive information, the information is
automatically run as Telop text on the stand-by
display.
To display the channel list
Press (i.ch).
● When you receive i-Channel information, " "→
" " flashes. Even if you receive information, the
FOMA terminal does not sound the ring tone
or vibrate, and the incoming indicator does not
operate, either.
● If you change the host, the Telop text may
be turned off and information may not be
automatically updated. To receive latest
information, press
channel list. The Telop text starts running
automatically.
● You can change the i-Channel host using the
Host selection (P.197). Normally, you do not need
to change the host.
● When the FOMA ter minal is powered off,
outside of the service area, or in poor radio
wave condition, you may not be able to receive
information. When you receive information by
pressing (i.ch), the Telop text is automatically
displayed in the stand-by display.
● Telop text is not displayed in the following cases.
- When the Lock all is set
- When the Personal data lock is set
- When the Omakase Lock is set
- When the Public mode (Drive mode) is set
- When the UIM is not inserted
- When the i-Channel or i-mode service is
canceled
(i.ch) and display the
Changing the i-Channel
Settings
Setting the Telop Text
You can set the display speed of the Telop text
and also turn off the Telop text.
1
From the i-mode menu, select [i-Channel]
→ [Ticker] and press
The Ticker display appears.
2
Set the speed for displaying the Telop text
at [Stand-by].
Select from [Fast], [Std], and [Slow].
To turn off the Telop text
Select [OFF].
● When 2in1 is used, you can set the Ticker for
each 2in1 mode.
Restoring the Default Settings
You can delete saved i-Channel data and reset
the Ticker settings to the default settings.
 If an i-motion or i-αppli is set for the stand-by
display, the Ticker settings are not reset.
1
From the i-mode menu, select [i-Channel]
→ [Reset i-Channel] and press
The screen for confirming whether to reset the
i-Channel data appears.
2
Select [Yes] and press
The i-Channel is reset.
.
.
.
203