Sony Ericsson FOMA SO905iCS Manual page 54

Table of Contents

Advertisement

2
Press
Calling
3
Press
See P.59 for sending the Chaku-moji and P.60 for placing a voice or videophone call by
specifying the condition.
For a voice call, you can also place it in the order of step 2 → step 1. Press
phone number, and the call is dialed automatically after about five seconds.
You are charged for digital communication even if you send a substitute image during a call.
If the videophone call is not connected, the following messages appear in the display. The
displayed message may not correctly represent the status of the recipient depending on the
type of the phone of the recipient or whether the recipient has subscribed to any network
service.
Message
Check number, then redial The phone number is no longer in use.
Busy
Busy with packet
transmission
Outside of service area/
power off
Set Caller ID to ON
Please try voice call
Connection failed
Please make your call
from the i-mode web page
Upper limit has been
exceeded. Connection failed
If you use the FOMA terminal to place a videophone call to emergency numbers (110, 119,
and 118), it automatically switches to voice call dialing.
52
.
A ringing sound is heard when the call is connected.
To place a videophone call
Press
(V.phone). When the call is answered, your image is sent to
the recipient and the call is switched to the hands-free operation that
allows you to hear the recipient's voice from the speaker.
When 2in1 is set to the Dual mode
Select [Number A]/[Number B] (P.398).
When a busy tone sounds
The line is busy. Press
When you hear a guidance
Call again according to the guidance.
to hang up.
The recipient is talking on the phone.
(This message may appear also during packet communication
on some recipient's terminals.)
The recipient is using packet communication.
The recipient is in a place where radio waves do not reach or
the phone is powered off.
This message appears when the call was connected without a
Caller ID (when a call is placed to Visual Net or other sites).
This message appears when the Call Forwarding Service is set
on the recipient's phone and the terminal to which the call was
forwarded is not equipped with the videophone function.
(As of December 2007, this message may appear also when
the Voice Mail Service is set on the recipient's phone.)
This message appears when none of the above reasons apply.
To view V-Live contents, visit and view an official i-mode site
once, and then place a videophone call.
The upper limit set to the plan with a Limit (Type Limit or Family
Wide Limit) has been exceeded.
to hang up and call again after a while.
Description
and enter a

Advertisement

Table of Contents
loading

Table of Contents