Sony Ericsson FOMA SO905iCS Manual page 199

Setting i-mode
Setting the Connection Timeout
The duration before disconnecting the FOMA
terminal automatically can be set when you
cannot send or receive data due to heavy
traffic at the i-mode center.
1
From the i-mode menu, select [i-mode
s e t t i n g ] → [ C o m m o n s e t t i n g ] →
[Connection timeout] and press
[60sec]:
Disconnect automatically when unable to send/
receive data for 60 seconds.
[90sec]:
Disconnect automatically when unable to send/
receive data for 90 seconds.
[Unlimited]:
Do not set the connection timeout (however, the
connection can be disconnected due to the radio
wave condition or other reasons).
2
Select the waiting duration and press
.
The Connection timeout is set.
Changing the i-mode Host (ISP
Connection Communication)
※ You do not need to change the Host setting
when using the i-mode service of DoCoMo.
You can set up to 10 hosts for receiving
services other than the services provided by
i-mode (DoCoMo). When you change a host
to other than [i-mode(UIM)], you cannot use
i-mode.
 You must always enter [Host name], [Host number],
and [Host address].
1
<i-mode setting>
.
2
3
4
5
6
●
From the i-mode menu, select [i-mode
setting] → [Common setting] → [Host
selection] and press
Ｈｏｓｔ ｓｅｌｅｃｔｉｏｎ
ｉ−ｍｏｄｅ（ＵＩＭ）
To edit the settings of the set host
Move the cursor to the set host and from the
Function menu, select [Edit], and enter the
Security code. Edit each item.
To delete the set host
Move the cursor to the set host and from the
Function menu, select [Delete one], enter the
Security code, and select [Yes].
Press (Create).
The Security code screen appears.
Enter the Security code and press
(OK).
Ｈｏｓｔ ｓｅｔｔｉｎｇ
Ｈｏｓｔ ｎａｍｅ
Ｈｏｓｔ ｎｕｍｂｅｒ
Ｈｏｓｔ ａｄｄｒｅｓｓ
Ｈｏｓｔ ａｄｄｒｅｓｓ２
[Host name]:
Enter a host name within eight full-width or 16
half-width characters.
[Host number]:
Enter a host number within 99 half-width
alphanumeric characters and symbols.
[Host address]/[Host address2]:
Enter a host address within 30 half-width
alphanumeric characters and symbols.
Enter each item.
Press (Complete).
The entered host is saved.
Select the host and press
The host is changed.
Note that packet communication is not covered
by the Pake-Houdai/Pake-Houdai Full service if a
host of the packet communication is set to other
than [i-mode(UIM)].
.
.
197
Continued