Setting I-Αppli For The Stand-By Display; I-Αppli Stand-By; Managing I-Αppli - Sony Ericsson FOMA SO905iCS Manual

Setting i- α ppli for the
Stand-by Display
Only one supporting software can be set for
the i-αppli stand-by display. The software
that supports the i-αppli stand-by display is
identified by " / /
 When the software using network transmission is set
for the i-αppli stand-by display, it may not operate
properly depending on the radio wave condition.
 When you set the i-αppli stand-by display from
the i-αppli software list display, the image set for
the stand-by display in the Stand-by display is also
changed.
1
From the list of i-αppli software, select
the software and press
The Function menu appears.
2
Select [Stand-by display] → [Yes] and
press .
The i-αppli stand-by display is set and the icon
(P.240) changes to indicate that the software is set
for the stand-by display.
To operate the software set for the i-αppli stand-by
display
Press ( ) in the i-αppli stand-by display.
● The message confirming whether to start the
i-αppli stand-by display appears when the
FOMA terminal is powered on if the i-αppli
stand-by display is set. Select [No] not to start
it. Select [Yes] or leave it for a while to start the
i-αppli stand-by display.
● If the Lock all or Personal data lock is set or 2in1
is set to the Dual or B mode while you set the
i-αppli stand-by display, the i-αppli stand-by
display is temporarily terminated. When you
cancel the Lock all or Personal data lock, the
i-αppli stand-by display reappears.
● The Web To cannot be used from the i-αppli
stand-by display.
● If an error which could terminate the i-αppli
stand-by display occurs, the time of error
occurrence can be checked in the stand-by error
history.
● If a security error occurs in the i-αppli stand-by
display, " " (Stand-by SW error) appears in the
stand-by display.
<i-αppli stand-by>
".
(Func).
Terminating the i-αppli Stand-by
Display
The i-αppli stand-by display is terminated and
the normal stand-by display is set.
1
From the list of i-αppli software, select
the software and press
The Function menu appears.
2
Select [Stand-by display] → [Cancel] and
press .
[End]:
End the i-αppli stand-by display once and
redisplay without terminating it.
[Cancel]:
Terminate the i-αppli stand-by display.
The i-αppli stand-by display is terminated.
Managing i- α ppli
 For some software, IP (information service providers)
may access the software saved in the mobile phone
and directly stop the use of it. In this case, most
operations including starting the software, setting
the software for the stand-by display, and upgrading
the software are disabled and only deleting the
software and displaying the software information
are available. To use the software again, you need
to request IP to resume the use of the software. For
more details, contact IP.
 For some software, IP (information service providers)
may send data to the software saved in the mobile
phone.
 When IP (information service providers) sends a
stop/resume request or data to the software, the
mobile phone starts to communicate with IP and
" " flashes. No packet communication charge is
required.
(Func).
247
Continued