Chapter 24 Configuring Span And Rspan; Understanding Span And Rspan - Cisco Catalyst 2950 Software Configuration Manual

Configuring SPAN and RSPAN
This chapter describes how to configure Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN)
on your Catalyst 2950 or Catalyst 2955 switch.
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
This chapter consists of these sections:
•
•
•
•

Understanding SPAN and RSPAN

You can analyze network traffic passing through ports by using SPAN to send a copy of the traffic to
another port on the switch that has been connected to a SwitchProbe device or other Remote Monitoring
(RMON) probe or security device. SPAN mirrors received or sent (or both) traffic on one or more source
ports to a destination port for analysis.
For example, in
port). A network analyzer on port 8 receives all network traffic from port 4 without being physically
attached to port 4.
78-11380-12
Understanding SPAN and RSPAN, page 24-1
Configuring SPAN, page 24-7
Configuring RSPAN, page 24-12
Displaying SPAN and RSPAN Status, page 24-17
Figure 24-1, all traffic on port 4 (the source port) is mirrored to port 8 (the destination
C H A P T E R
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
24
24-1