Pbx Configuration-[1-1] Configuration-Slot-V-Ipgw-Port Property - Panasonic KX-NS500 Pc Programming Manual

9.12 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Port Property
9.12 PBX Configuration—[1-1]
Configuration—Slot—V-IPGW—Port Property
Various settings can be programmed for each virtual IP Gateway port.
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Trunk Adaptor
To connect to a Trunk Adaptor, follow the steps below.
1.
Ensure that the Trunk Adaptor is connected to the network and a power supply.
2.
Click Trunk Adaptor. The Trunk Adaptor List screen is displayed.
3.
Enter a name (20 characters or less) for the Trunk Adaptor in Trunk Adaptor Name.
4.
Enter the Trunk Adaptor's IP address in Trunk Adaptor IP Address.
5.
To confirm that the setting is correct, click CONNECT. If the setting is correct, the Trunk Adaptor's Web
Maintenance Console will open in a new browser window.
For details about the Trunk Adaptor's Web Maintenance Console, refer to the documentation of the Trunk
Adaptor.
6.
Click OK.
Connection
Indicates the port status. To change the status of the port, click the desired cell in the column, and then select
INS or OUS for the port.
This option is only available in On-line mode.
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Maintenance Console Location
9.12 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Port Property
Connection Attribute
Specifies whether to connect a port to a Trunk Adaptor or use it as an IP gateway.
Value Range
Gateway, Trunk Adaptor
Maintenance Console Location
9.12 PBX Configuration—[1-1] Configuration—Slot—V-IPGW—Port Property
Feature Guide References
5.3.1 Trunk Adaptor Connection
296 PC Programming Manual