Panasonic KX-NS500 Pc Programming Manual page 878

20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
Auto Login TRG No.
Specifies the trunk number for Automatic Login. When the Unified Messaging system receives a call on this
trunk, the caller (subscriber) is automatically logged in to the mailbox. Note that this number must be unique
for each mailbox.
Value Range
1–64
Feature Guide References
3.2.2.2 Automatic Login
Auto Login DDI/DID, TRG No. Password Entry Requirement
Specifies if a password is required for entry when automatic login is performed using the trunk group number
or the DID number.
Value Range
Yes, No
Notice
If this is set to "No", ensure that unauthorised third-parties are not allowed access to any extensions using
the specified trunk group number.
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Remote Call/Automatic Login/Direct Service
Feature Guide References
3.2.2.2 Automatic Login
Auto Login Toll Saver
Allows subscribers to call the Unified Messaging system and know whether or not new messages have been
recorded in their mailboxes by the number of rings they hear before the Unified Messaging system answers
their calls. Toll Saver is available under the same conditions as Automatic Login; subscribers can use Toll
Saver when calling from an outside telephone whose number is stored as a Caller ID number, or by dialling a
telephone number assigned to a specified DID number or trunk.
Value Range
Disable: Disables the Toll Saver feature.
DID: Toll Saver functions when the system receives the pre-programmed DID number from the PBX.
Caller ID: Toll Saver functions when Caller ID information is received that matches one of the pre-programmed
numbers (Caller ID 1 or 2).
Trunk: Toll Saver functions when the system receives a call on the pre-programmed trunk.
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Remote Call/Automatic Login/Direct Service
878 PC Programming Manual