Panasonic KX-NS500 Pc Programming Manual page 865

Telephone Device—Device No. 1, 2, 3—No Answer Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits before retrying message notification when
the called device does not answer.
Value Range
1–120 min
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Use Mode
Specifies if and how each device is used for message notification. The subscriber can also specify the use
mode from his or her telephone.
Schedule: If Scheduled is selected here, follow the steps below to specify the time frame:
1.
Select a day from the Day drop-down list (Sunday – Saturday).
2.
Click Enable Time Frame No. 1 or 2.
3.
Enter the start and end times in the Start At (HH:MM) and End At (HH:MM) fields.
4.
Repeat steps 1 to 3 for each day to be programmed, and then click OK.
Value Range
Not use: The selected device is not used for message notification.
Continuously: The device is called whenever a message is recorded in the mailbox. If Only Urgent
Messages is set to "Yes", the device is called whenever an urgent message is recorded in the mailbox.
Scheduled: The selected device is called only during the selected times.
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device Notification Timer—Device Start Delay Time (0-120
min)
Specifies the length of time the system waits after a new message is received before sending message waiting
notification.
Value Range
0–120 min
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
PC Programming Manual 865