13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
Maintenance Console Location
13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
PC Programming Manual References
9.1 PBX Configuration—[1-1] Configuration—Slot
Feature Guide References
2.16.3 Built-in Simplified Voice Message (SVM)
SVM Cyclic Tone Option—Repeating Times of ON/OFF for Detection
Specifies the number of times the tone pattern (a set of tone-on and tone-off) must be received to establish
reception of the cyclic tone. This determines the end of call.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to "Option".
Value Range
3-16
Maintenance Console Location
13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
Feature Guide References
2.16.3 Built-in Simplified Voice Message (SVM)
SLT Dial "*" Operation Mode
Specifies the SLT dial "*" operation mode to avoid wrong DTMF signal detection from the SLT. If "Enable" is
selected, you need to dial "*" before dialling.
Value Range
Enable, Disable
Maintenance Console Location
13.3.3 PBX Configuration-[5-3-3] Option Device - Voice Message - SVM
Feature Guide References
2.16.3 Built-in Simplified Voice Message (SVM)
752
PC Programming Manual