Cable Routing - Yamaha RS90GTZ Service Manual

SPEC

CABLE ROUTING

CABLE ROUTING
Tighten the ground lead
together with the flange bolt
above the rectifier/regulator
(point the terminal with the rivet
facing upward).
Pass the stator coil lead
between the rectifier/regulator
lead and the ground lead, and
then route it over the leads.
Fasten the wire harness and
stator coil lead with the holder.
Positive battery lead
Negative battery lead
Positive battery lead coupler
Fasten the wire harness and
stator coil lead with a plastic
band.
Negative battery lead coupler
Main fuse
Fasten the positive battery lead
and negative battery lead with
the holder.
Insert the projection on the wire
harness holder into the hole in
the frame cross member.
Route the stator coil lead under
the battery bracket.
Fasten the starter motor lead
and oil tank inlet hose with a
plastic band. Point the end of
the plastic band outward.
Pass the oil level switch lead to
front of the headlight stay.
Oil level switch
To parking brake
Fasten the wire harness to the
battery bracket with a plastic
band. Point the end of the plas-
tic band rearward.
Headlight couplers
Injector #3
ISC (idle speed control) unit
Fasten the wire harness to the
fuel rail with a plastic band.
Point the end of the plastic band
rearward.
0 – 10 mm (0 – 0.39 in)
Injector #2
Intake air pressure sensor 1
(cylinders #1, #2, and #3)
To speedometer unit
Intake air pressure sensor 2
(cylinder #1)
Injector #1
9-26