Yamaha RS90GTZ Service Manual page 300

CONNECTING RODS AND PISTONS
5-75
7. Install:
• Big end bearings
• Connecting rod assembly
(into the cylinder and onto the crankshaft
pin).
• Connecting rod cap
(onto the connecting rod)
TIP
• Align the projections on the big end bearings
with the notches in the connecting rods and
connecting rod caps.
• Be sure to reinstall each big end bearing in its
original place.
• While compressing the piston rings with pis-
ton ring compressor
rod assembly into the cylinder with the other
hand.
• Make sure that the "Y" marks
necting rods face towards the right side (AC
magneto rotor side) of the crankshaft.
• Make sure that the characters
connecting rod and connecting rod cap are
aligned.
Piston ring compressor:
YM-08037, 90890-05158
ENG
, install the connecting
on the con-
on both the