Yamaha RS90GTZ Service Manual page 485

SPEC
CABLE ROUTING
Air filter case latch
Route the coolant reservoir
breather hose behind the
engine and front of the heat
exchanger.
Pass the plastic band through
the hole in the frame, and then
fasten the coolant reservoir
breather hose at the white paint
mark. Install the plastic band
with the buckle facing outward
and the end pointing forward.
To tail/brake light
Route the wire harness outside
of the fuel tank right side cover.
Fasten the wire harness and
radiator fan motor lead with the
holder, and then fasten the
holder with the frame cross
member and frame.
Fuse box bracket
Fuse box
After bending the fuel tank
breather hose, fasten the hose
protector near the frame cross
member. Route the fuel tank
breather hose behind the frame
cross member as shown in the
illustration.
Hose protector
Route the fuel tank breather
hose behind the frame cross
member.
Coolant reservoir
Gear position switch lead
Fasten the gear position switch
lead with the holder.
Brake hose
Parking brake cable
Fasten the coolant reservoir
breather hose and front heat
exchanger air bleed hose with
the holder.
Fasten the parking brake cable
with the holder, and then bend
the holder downward 90°.
Route the starter motor lead
inner side of the oil cooler outlet
hose.
9-52