DRIVE CHAIN HOUSING
INSTALLATION (RST90GTZ)
1. During installation, pay attention to the fol-
lowing.
Properly install the rubber seal onto the drive
chain housing, making sure that there are no
gaps.
Be sure to install the collars in their original
positions, otherwise the secondary shaft will
stick.
0.2 ~ 0.7 mm (0.008 ~ 0.028 in)
: ESSO beacon 325 grease or Aeroshell
grease #7A
For the secondary shaft and drive chain hous-
ing
installation,
SHAFT".
2. Install:
• Lever rod
3. Adjust:
• Lever rod length
Adjustment steps:
• Loosen the locknuts
• Turn the lever rod
fied length is obtained.
Lever rod length:
27 mm (1.06 in)
• Tighten the locknuts.
4-30
POWR
TR
refer
to
"SECONDARY
.
in or out until the speci-