Yamaha RS90GTZ Service Manual page 463

SPEC
CABLE ROUTING
#3 mark
Insert the projection of the
holder into the hole in the head-
light stay and fasten the fuel
hose. Face the catch of the
holder either up/down.
Fasten the wire harness to the
frame cross member with the
plastic band.
Insert the projection of the
holder into the hole in the head-
light stay and fasten the brake
hose. Face the catch of the
holder either up/down.
Coolant temperature sensor
coupler
To gear position switch
To brake caliper
To main switch
Main switch coupler
To heat exchanger
Face the cutout in the hose joint
flange to the fuel tank.
Face the catch of the hose
clamp to the fuel tank.
Insert the shorter L-shaped fuel
tank breather hose into the fuel
tank, and then point the longer
portion of the hose to right.
Route the tail sub-wire harness
above the projection of the fuel
tank right side cover.
Fuel hose
To tail/brake light
Fuel hose connector holder
Set the locating dumper
between the fuel tank and seat.
Face the catch of the hose
clamp to front.
Route in the order of parking
brake cable, throttle cable,
brake hose and corrugated tube
from the bottom within the two-
dot-dashed line.
To speed sensor
To relay
Pass the brake light switch lead
and left grip warmer lead over
the parking brake cable.
Brake hose
Speed sensor coupler
9-30