Yamaha RS90GTZ Service Manual page 182

BRAKE
2. Install:
• Brake pads
• Pad spring
Installation steps:
• Connect a suitable hoses
iper bleed screws
each hose into an open container.
• Loosen the caliper bleed screws and push
the pistons into the caliper with your finger.
• Tighten the caliper bleed screws
Bleed screw:
6 Nm (0.6 m•kgf, 4.3 ft•lbf)
• Install the brake pads and pad spring.
RS90GTZ/RS90LTGTZ
RST90GTZ
3. Check:
• Brake fluid level
Refer to "BRAKE FLUID LEVEL INSPEC-
TION" in CHAPTER 2.
4. Check:
• Brake lever operation
A soft or spongy feeling → Bleed brake sys-
tem.
Refer to "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" in CHAPTER 2.
4-41
POWR
TR
tightly to the cal-
. Put the other end of
.