Yamaha RS90GTZ Service Manual page 132

STEERING
6. Adjust:
• Skis
Adjustment steps:
• Temporarily install the handlebar.
• Hold the handlebar straight and check that
the skis and relay arms are at right angles to
the handlebar.
• Install the steering linkage alignment plate
to the relay arms
Steering linkage alignment plate:
YS-01487
Steering link holder:
90890-01487
• Loosen the locknuts (steering shaft)
• Turn the steering shaft
adjust the handle so that it is set in a straight
line.
Turning the steering
shaft in direction
Turning the steering
shaft in direction
• Tighten the locknuts (steering shaft)
Steering shaft locknut:
25 Nm (2.5 m•kgf, 18 ft•lbf)
LOCTITE
• Adjust each angle of right and left skis by
turning the tie rod respectively.
• Measure the ski toe-out.
Refer to "STEERING SYSTEM" in CHAPTER
2.
• Remove the steering linkage alignment plate
(steering link holder)
3-18
CHAS
.
.
left to right and
Turning the
handlebar
in direction
Turning the
handlebar
in direction
.
®
.