Engine Oil Level Inspection - Yamaha RS90GTZ Service Manual

COMPRESSION PRESSURE MEASUREMENT/

ENGINE OIL LEVEL INSPECTION

8. Install:
• All removed parts
TIP
For installation, reverse the removal proce-
dure.
ENGINE OIL LEVEL INSPECTION
1. Inspect:
• Engine oil level
NOTICE
Do not run the engine with too much or not
enough oil in the oil tank. Oil could flow
into the air filter and the engine could be
damaged.
Inspection steps:
• Place the snowmobile on a level surface and
apply the parking brake.
• Start the engine, warm it up for 10 ~ 15 min-
utes, and then turn off.
• Remove the side cover (right).
Refer to "COWLINGS" in CHAPTER 3.
• Disconnect the oil level switch coupler
NOTICE
Disconnect the oil level switch coupler
before removing the oil level gauge. Other-
wise the lead can twist and become sev-
ered.
• Remove the oil level gauge
insert it back into the filler hole (without
screwing it in), and then remove it again to
check the oil level.
• The engine oil level should be between the
maximum level mark "H"
level mark "L"
Below the minimum level mark → Add the
recommended engine oil to the proper level.
NOTICE
When adding the engine oil, be careful not
to fill above the maximum level mark "H"
and minimum level mark "L" on the oil level
gauge.
2-22
INSP
ADJ
, wipe it clean,
and minimum
.
.