HEADLIGHT BEAM ADJUSTMENT
HEADLIGHT BEAM ADJUSTMENT
1. Place the snowmobile on a level surface.
2. Place the snowmobile in front of a wall at
3. Measure the distance
4. With a person sitting on the snowmobile,
5. Switch on the headlight's high beam and
6. Adjust:
Adjustment steps:
• Remove the top cover.
• Turn the adjusting screw
Direction
Direction
2-53
the recommended distance
table below.
the center of the headlight and place a
mark on the wall at that height.
apply the parking brake, start the engine
and let it idle.
check the height of the projected beam on
the wall. The projection should be at the
position marked in step 3 or 1/2° lower (set
range
).
3.0 m (10 ft)
26 mm (1.0 in)
: Distance
: Height
• Headlight beam (vertically)
Refer to "COWLINGS" in CHAPTER 3.
to adjust the headlight beams.
Headlight beam is lowered.
Headlight beam is raised.
INSP
ADJ
. Refer to the
from the floor to
7.6 m (25 ft)
66 mm (2.6 in)
: Set range
in direction
or