Yamaha RS90GTZ Service Manual page 110

REAR SUSPENSION
Control rod
RS90GTZ/RS90LTGTZ
1. Adjust:
• Control rod stroke
Adjustment steps:
• Loosen the locknut
• Turn the control rod adjuster
or to adjust the control rod stroke.
Adjusting
MIN
position
Decrease
Effect
Pitching
Standard Fourth mark to the left of MAX
• Check the adjuster length
on the special wrench
owner's tool kit as shown. Make sure that the
rim of the control rod body is within the
range of the scale.
• While holding the adjuster securely, tighten
the locknut.
Control rod adjusting locknut:
35 Nm (3.5 m•kgf, 25 ft•lbf)
NOTICE
When using the special wrench, make sure
that it is situated at a right angle to the con-
trol rod, and that it is tightly fitted to the
locknut or the control rod adjuster.
WARNING
Never adjust the control rod beyond the
range of the scale on the special wrench.
RST90GTZ
1. Adjust:
• Control rod stroke
NOTICE
Make sure the adjusting nut ends are set at
the same position on each side.
2-87
INSP
ADJ
.
in direction
STD MAX
Increase
← →
weight
transfer
using the scale
included in the