Yamaha RS90GTZ Service Manual page 465

SPEC
CABLE ROUTING
Position the headlight sub-wire
harness coupler outermost of all
the other harnesses.
Connect the fuel sender cou-
pler, making sure that the cou-
pler is positioned under the fuel
hose.
Route the auxiliary DC jack cou-
pler above the fuel hose and
below the headlight sub-wire
harness and connect the cou-
pler.
To auxiliary DC jack
After connecting the ignition
system sub-wire harness cou-
pler, slide the rubber cover over
it.
#1 mark
Fasten the wire harness and
ignition system sub-wire har-
ness to the frame cross mem-
ber with the plastic band. Point
the end of the plastic band rear-
ward.
Pass the corrugated tubes, hel-
met shield heater jack lead,
brake hose, parking brake cable
and throttle cable through the
lower guide. Route the throttle
cable behind the brake hose.
Fasten the DC back buzzer lead
and bend the holder 90°.
Fasten the radiator fan motor
lead and bend the holder 90°.
Bolt
DC back buzzer
Flange nut
9-32