Brake System - Yamaha RS90GTZ Service Manual

GENERAL MAINTENANCE AND LUBRICATION CHART
ITEM
* Drive chain oil
* Brake and parking brake
Control cables
* Disc brake installation
* Slide runners
* Extrovert sprocket wheels
* Skis and ski runners
* Steering system
* Steering bearings
Skis and front shock
*
absorbers
* Suspension component
Fittings and fasteners
* Battery
TIP

Brake system:

• After disassembling the master cylinder or caliper cylinder, always change the brake fluid.
Regularly check the brake fluid level and add fluid if necessary.
• Replace the oil seals of the master cylinder and caliper cylinder every two years.
• Replace the brake hose every four years, or if cracked or damaged.
REMARKS
• Check oil level.
• Change.
• Adjust free play and/or replace pads if necessary.
• Change brake fluid.
• Make sure that operation is smooth.
• Lubricate if necessary.
• Check for slight free play.
• Lubricate shaft with specified grease as required.
• Check for wear and damage.
• Replace if necessary.
• Check for wear and damage.
• Replace if necessary.
• Check for wear and damage.
• Replace if necessary.
• Check toe-out.
• Adjust if necessary.
• Check bearing assemblies for looseness.
• Lubricate with specified grease.
• Lubricate with specified grease.
• Lubricate with specified grease.
• Make sure that all nuts, bolts and screws are properly tightened.
• Tighten if necessary.
• Check condition.
• Charge if necessary.
2-2
INSP
ADJ
INITIAL EVERY
1 month Seasonally
or 800 km or 4,000 km
(500 mi) (2,500 mi)
(40 hr) (200 hr)
See TIP following this chart.
Every 1,600 km (1,000 mi)