Wheel Installation; Battery - Yamaha VIKING VI 2021 Owner's Manual

EBU33031

Wheel installation

1. Install the wheel and the nuts.
TIP
For YXC70VPXN: be sure to install the nuts
with their tapered side towards the wheel.
YXC70VPXN
9
1. Tapered nut
2. Lower the vehicle so that the wheel is on
the ground.
3. Tighten the wheel nuts in a crisscross
pattern to the specified torque.
EWB03400
WARNING
Do not reverse the rims on your Yamaha
Viking VI to widen the track width. Install-
ing wheels improperly increases the risk of
wheel failure and accidents.
Tightening torques:
Front wheel nut:
75 N·m (7.5 kgf·m, 55 lb·ft)
Rear wheel nut:
1
75 N·m (7.5 kgf·m, 55 lb·ft)
EBU32643

Battery

This model is equipped with a 12–volt VRLA
(valve–regulated lead–acid) battery. There is
no need to check the electrolyte or to add dis-
tilled water. However, the battery lead con-
nections need to be checked and tightened,
and the battery terminals cleaned if corroded.
If the battery seems to have discharged, re-
charge it as soon as possible.
9-42