Wheel Installation; Battery - Yamaha VIKING YXM70VPXK 2016 Owner's Manual

EBU33031

Wheel installation

1. Install the wheel and the nuts.
TIP
For YXM70VPXK: be sure to install the nuts
with their tapered side towards the wheel.
YXM70VPXK
8
1. Tapered nut
2. Lower the vehicle so that the wheel is on
the ground.
3. Tighten the wheel nuts in a crisscross
pattern to the specified torque.
EWB03400
WARNING
Do not reverse the rims on your Yamaha
Viking to widen the track width. Installing
wheels improperly increases the risk of
wheel failure and accidents.
Tightening torques:
Front wheel nut:
75 N·m (7.5 kgf·m, 55 lb·ft)
Rear wheel nut:
1
75 N·m (7.5 kgf·m, 55 lb·ft)
EBU32643

Battery

This model is equipped with a 12–volt VRLA
(valve–regulated lead–acid) battery. There is
no need to check the electrolyte or to add dis-
tilled water. However, the battery lead con-
nections need to be checked and tightened,
and the battery terminals cleaned if corroded.
If the battery seems to have discharged, re-
charge it as soon as possible.
8-43