Lre Message Logging Process; Configuring Lre Ports - Cisco Catalyst 2950 Software Configuration Manual

Configuring LRE Ports

LRE Message Logging Process

The Catalyst 2950 LRE switch software monitors switch conditions on a per-port basis and sends the
debugging messages to an LRE message logging process that is different than the system message
logging process described in
These options are available in the LRE logging process:
•
•
•
•
You can use the logging lre interface configuration command to specify the mode in which to log LRE
events. To display the events on the LRE interfaces, use the show controllers lre log privileged EXEC
command. For more information about these commands, see the command reference for this release.
If the syslog export feature is enabled, the switch sends the information to the LRE message logging
process and to the system message logging process. For information about configuring this feature, see
the
Configuring LRE Ports
These sections describe configuration guidelines and how to assign a profile to all or to individual LRE
ports. These sections contain more information about LRE links, ports, and profiles:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
12-8
Chapter 26, "Configuring System Message Logging."
Disabled—The switch does not log LRE events.
Event—The switch logs only LRE events.
Extended—The switch logs LRE events and all the LRE parameters.
Normal—The switch logs LRE events and the typical LRE parameters.
"Configuring Syslog Export" section on page
Default LRE Configuration, page 12-9
Environmental Guidelines for LRE Links, page 12-9
Guidelines for Using LRE Profiles, page 12-10
CPE Ethernet Link Guidelines, page 12-11
Assigning a Global Profile to All LRE Ports, page 12-12
Assigning a Profile to a Specific LRE Port, page 12-13
Assigning a Global Sequence to All LRE Ports, page 12-13
Assigning a Sequence to a Specific LRE Port, page 12-14
Using Rate Selection to Automatically Assign Profiles, page 12-14
Configuring LRE Link Persistence, page 12-19
Configuring LRE Link Monitor, page 12-20
Configuring LRE Interleave, page 12-20
Configuring Upstream Power Back-Off, page 12-21
997 switch) (optional)
Configuring CPE Toggle, page 12-22
Configuring Syslog Export, page 12-23
12-23.
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(available only on the Catalyst 2950ST-24 LRE
(optional)
(optional)
Chapter 12 Configuring LRE
(optional)
78-11380-12