Configuring The Ip Security Associations Table; Figure 3-64: Ip Security Associations Table; Table 3-13: Default Ipsec/Ike Proposals - AudioCodes Mediant 1000 User Manual

Parameter Name
Diffie Hellman Group
[IPsecProposalTable_DHGroup]
If no proposals are defined, the default settings (shown in the following table) are applied.
Proposal
Proposal 0
Proposal 1
Proposal 2
Proposal 3
3.3.4.7

Configuring the IP Security Associations Table

The 'IP Security Associations Table' page allows you to configure up to 20 peers (hosts or
networks) for IP security (IPSec)/IKE. Each of the entries in the IPSec Security Association
table controls both Main Mode and Quick Mode configuration for a single peer
Note:

To configure the IPSec Association table:
1. Open the 'IP Security Associations Table' page (Configuration tab > Security
Settings menu > IPSec Association Table
below shows sections of this table.)
2. Add an Index or select the Index rule you want to edit.
3. Configure the rule according to the table below.
SIP User's Manual

Table 3-13: Default IPSec/IKE Proposals

Encryption
3DES
3DES
3DES
3DES
You can also configure the IP Security Associations table using the ini file
table parameter IPsecSATable (refer to ''Security Parameters''
Figure 3-64: IP Security Associations Table Page
Description
Determines the length of the key created by the
DH protocol for up to four proposals. For the
file parameter, X depicts the proposal number (0
to 3).

[0] Group 1 (768 Bits) = DH-786-Bit

[1] Group 2 (1024 Bits) (default) = DH-1024-
Bit
Authentication
SHA1
MD5
SHA1
MD5
). (Due to the length of the table, the figure
96
Mediant 600 & Mediant 1000
DH Group
Group 2 (1024 bit)
Group 2 (1024 bit)
Group 1 (786 bit)
Group 1 (786 bit)
on page 271
Document #: LTRT-83306
ini
).