Create Wac User - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Command: config wac virtual_ip 1.1.1.1
Success.
DGS-3620-28PC:admin#
121-9 config wac switch_http_port
Description
This command is used to configure the TCP port which the WAC switch listens to. The TCP port
for HTTP or HTTPs is used to identify the HTTP or HTTPs packets that will be trapped to CPU for
authentication processing, or to access the login page. If not specified, the default port number for
HTTP is 80, and the default port number for HTTPS is 443. If no protocol is specified, the protocol
is HTTP.
Format
config wac switch_http_port <tcp_port_number 1-65535> {[http | https]}
Parameters
<tcp_port_number 1-65535> - Enter a TCP port which the WAC switch listens to and uses to
finish the authenticating process.
http - (Optional) Specifies that WAC runs HTTP protocol on this TCP port.
https - (Optional) Specifies that WAC runs HTTPS protocol on this TCP port.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a TCP port which the WAC switch listens to:
DGS-3620-28PC:admin# config wac switch_http_port 8888 http
Command: config wac switch_http_port 8888 http
Success.
DGS-3620-28PC:admin#

121-10 create wac user

Description
This command is used to create accounts for Web-based Access Control. This user account is
independent of the login user account. If VLAN is not specified, the user will not get a VLAN
assigned after the authentication.
Format
create wac user <username 15> {[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
1272