D-Link xStack DGS-3620 Reference Manual page 1243

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add a user-defined OUI of a voice device:
DGS-3620-28PC:admin#config voice_vlan oui add 00-0A-0B-00-00-00 FF-FF-FF-00-00-
00
Command: config voice_vlan oui add 00-0A-0B-00-00-00 FF-FF-FF-00-00-00
Success.
DGS-3620-28PC:admin#
118-5 config voice_vlan ports
Description
This command is used to enable or disable the voice VLAN function on ports or mode per port.
Format
config voice_vlan ports [<portlist> | all] [state [enable | disable] | mode [auto | manual]]
Parameters
<portlist> - Enter a range of ports to set.
all - Specifies to set all ports.
state - Specifies the voice VLAN function state on ports. The default state is disabled.
enable - Specifies to enable the voice VLAN function state on ports.
disable - Specifies to disable the voice VLAN function state on ports.
mode - The voice VLAN mode. The default mode is auto.
auto - When the mode is auto, the port may become the voice VLAN member port by auto-
learning. If the MAC address of the received packet matches the configured OUI, the port
will be learned as dynamic member port. The dynamic membership will be removed via the
aging out mechanism.
manual - When the mode is set to manual, the port needs to be manually added into or
removed from the voice VLAN by 802.1Q VLAN configuration command.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure voice VLAN ports 4 to 6 to enable:
DGS-3620-28PC:admin#config voice_vlan ports 4-6 state enable
Command: config voice_vlan ports 4-6 state enable
Success.
DGS-3620-28PC:admin#
1238