Control Panel Assembly Removal - Lexmark Pro5500t Service Manual

4447-20x

Control panel assembly removal

Warning: Do not interchange screws during reinstallation, as it may damage the machine. Always take note of
their original placement.
1.
Remove the power supply. See
2.
Remove the duplex unit. See
3.
Remove the rear cover. See
4.
Remove the left cover. See
5.
Remove the right cover. See
6.
Disconnect the control panel FFC (A), and the plastic screw (B) at the right side of the printer.
Installation note: When replacing the control panel FFC, be sure to place it behind the cable holder (A) as
4-35
Service Manual
"Power supply removal" on page
"Duplex unit removal" on page
"Rear cover removal" on page
"Left cover removal" on page
"Right cover removal" on page
B A
shown.
4-10.
4-11.
4-25.
4-26.
4-29.
A
Previous
Next
Go Back
Disassembly
Flow chart