4447-20x
Rear cover removal
Warning: Do not interchange screws during reinstallation, as it may damage the machine. Always take note of
their original placement.
1.
Remove the power supply. See
2.
Remove the duplex unit. See
3.
Remove the five screws (A) securing the rear cover to the printer.
4.
Hold the center section of the rear cover, and free the snaps from the left side to remove.
4-25
Service Manual
"Power supply removal" on page
"Duplex unit removal" on page
A
B
4-10.
4-11.
Previous
Next
Go Back
Disassembly
Flow chart