Tank Receiver Assembly With Inlet Removal - Lexmark Pro5500t Service Manual

4447-20x

Tank receiver assembly with inlet removal

Warning: Do not interchange screws during reinstallation, as it may damage the machine. Always take note of
their original placement.
1.
Remove the power supply. See
2.
Remove the duplex unit. See
3.
Remove the rear cover. See
4.
Remove the left cover. See
5.
Remove the right cover. See
6.
Remove the control panel assembly. See
7.
Remove the wireless card. See
8.
Remove the card reader. See
9.
Remove the ADF/scanner assembly. See
10.
Remove the midframe cover. See
11.
Remove the lower front cover. See
12.
Remove the alignment sensor. See
13.
Remove the printhead carrier assembly with tank receiver assembly. See
with tank receiver assembly removal" on page
14.
Remove the printhead carrier card. See
15.
Remove the printhead. See
16.
Remove the tank receiver assembly with inlet.
This is the photo of the tank receiver assembly with inlet.
4-79
Service Manual
"Power supply removal" on page
"Duplex unit removal" on page
"Rear cover removal" on page
"Left cover removal" on page
"Right cover removal" on page
"Control panel assembly removal" on page
"Wireless card removal" on page
"Card reader removal" on page
"ADF/Scanner assembly removal" on page
"Midframe cover removal" on page
"Front cover removal" on page
"Alignment sensor removal" on page
4-60.
"Printhead carrier card removal" on page
"Printhead removal" on page
4-10.
4-11.
4-25.
4-26.
4-29.
4-38.
4-40.
4-50.
4-55.
4-57.
"Printhead carrier assembly
4-67.
4-73.
Previous
Next
Go Back
4-35.
4-42.
Disassembly
Flow chart