Print Engine Assembly Removal - Lexmark Pro5500t Service Manual

Print engine assembly removal

Warning: Do not interchange screws during reinstallation, as it may damage the machine. Always take note of
their original placement.
1.
Remove the ink tank door. See
2.
Remove the input tray. See
3.
Remove the power supply. See
4.
Remove the duplex unit. See
5.
Remove the rear cover. See
6.
Remove the left cover. See
7.
Remove the right cover. See
8.
Remove the system board. See
9.
Remove the control panel assembly. See
10.
Remove the wireless card. See
11.
Remove the card reader. See
12.
Remove the ADF/scanner assembly. See
13.
Remove the midframe cover. See
14.
Remove the print zone felt assembly. See
15.
Remove the encoder strip. See
16.
Remove the lower front cover. See
17.
Remove the alignment sensor. See
18.
Remove the printhead carrier assembly with the tank receiver assembly. See
assembly with tank receiver assembly removal" on page
The print engine assembly remains.
"Ink tank door removal" on page
"Input tray removal" on page
"Power supply removal" on page
"Duplex unit removal" on page
"Rear cover removal" on page
"Left cover removal" on page
"Right cover removal" on page
"System board removal" on page
"Control panel assembly removal" on page
"Wireless card removal" on page
"Card reader removal" on page
"ADF/Scanner assembly removal" on page
"Midframe cover removal" on page
"Encoder strip removal" on page
"Encoder strip removal" on page
"Front cover removal" on page
"Alignment sensor removal" on page
4-6.
4-8.
4-10.
4-11.
4-25.
4-26.
4-29.
4-32.
4-38.
4-40.
4-50.
4-53.
4-53.
4-55.
4-57.
"Printhead carrier
4-60.
Repair information
4447-20x
Previous
Next
Go Back
4-35.
Disassembly
Flow chart
4-42.
4-84