Table of Contents
Advertisement
Removing the server top cover and bezel
Removing the top cover
Review the information in "Before you begin" on page 7 through "Handling static-
sensitive devices" on page 8.
Note: The illustrations in this book might differ slightly from your hardware.
Top cover
Captive screws
To remove the server top cover:
1.
Loosen the two screws on the back edge of the top cover.
2.
Slide the top cover slightly toward the rear of the server. Lift the cover off the
server and set the cover aside.
Attention: For proper cooling and airflow, replace the top cover after installing or
removing an option. Operating the server for extended periods of time (over 30
minutes) with the top cover removed might damage server components.
Chapter 2. Installing options
9
Advertisement
Table of Contents
