Removing A Usb Embedded Hypervisor Flash Device - IBM System x3850 X6 Installation And Service Manual

Hide thumbs Also See for System x3850 X6:

Table of Contents

Removing a USB embedded hypervisor flash device

Use this information for instructions on how to remove a USB hypervisor flash

About this task

To remove a USB embedded hypervisor flash device, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

and "Installation guidelines" on page 45.

2. Turn off the server (see "Turning off the server" on page 41) and all attached

peripheral devices. Disconnect all power cords; then, disconnect all external

cables as necessary to replace the device.

3. Remove the standard I/O book from the server (see "Removing the standard

I/O book" on page 221).

4. Locate the USB embedded hypervisor flash device connector on the standard

I/O book board (see "Standard I/O book" on page 32 for the location of the

Note: You can rotate the standard I/O book air baffle up, if needed, to access

the USB flash device connector.

5. Slide the lockbar on the USB flash device connector down to the unlocked

position and pull the USB flash device out of the connector.

Chapter 6. Removing and replacing components

System x3950 x6