Removing A Usb Embedded Hypervisor Flash Device - IBM System x3750 M4 Type 8722 Installation And Service Manual

Removing a USB embedded hypervisor flash device

To remove a USB embedded hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Remove the top cover (see "Removing the server top cover" on page 206).
4. If any adapters are installed in the PCI riser-card assembly, disconnect any
5. Remove the PCIe riser-card assembly (see "Removing a PCI riser-card
6. Locate the USB embedded hypervisor flash device connector on the system
7. Slide the lockbar on the USB flash device connector down to the unlocked
8. If you are instructed to return the flash device, follow all packaging
236
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
"Installation guidelines" on page 33.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
cables that are connected to the adapters.
assembly" on page 258).
board.
position and pull the USB flash device out of the connector.
USB Hypervisor key
Lockbar
instructions, and use any packaging materials for shipping that are supplied to
you.