Removing A Memory Module (Dimm) - IBM xSeries 306m Problem Determination And Service Manual

Removing a memory module (DIMM)

To remove a DIMM, complete the following steps:
DIMM
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 30).
4. Open the retaining clip on each end of the DIMM connector.
5. Lift the DIMM out of the connector.
6. Open the retaining clip on each end of the DIMM connector and remove the
7. If you are instructed to return the DIMM, follow all packaging instructions, and
38
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide
on page 27.
all external cables.
Attention: To ensure proper cooling and airflow, do not operate the server for
more than 2 minutes with the cover removed.
DIMM from the connector.
DIMM
use any packaging materials for shipping that are supplied to you.
Retaining
clip
Retaining
clip