Removing A Memory Module - IBM BladeCenter JS22 Problem Determination And Service Manual

7. Place the drive into the hard disk drive tray and push it toward the rear of the
8. Install and close the blade server cover. See "Installing and closing the blade
9. Install the blade server into the BladeCenter unit. See "Installing the blade

Removing a memory module

Remove a dual-inline memory module (DIMM).
Figure 14. Removing a memory module
1. Read "Safety" on page v and the "Installation guidelines" on page 237.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
248
JS22 Type 7998: Problem Determination and Service Guide
blade, into the connector until the drive moves past the lever at the front of the
tray.
Attention: Do not press on the top of the drive. Pressing the top might
damage the drive.
server cover" on page 243.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
server in a BladeCenter unit" on page 240.
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 239.
side up.
cover" on page 242.
DIMM
Retaining clip