Removing A Memory Module (Dimm) - IBM x3250 M2 Problem Determination And Service Manual

3. Follow the instructions that come with the drive to set any jumpers or switches.
4. Attach the drive-retention clip that you removed in "Removing a CD or CD/DVD
5. Slide the drive into the CD/DVD drive bay until the drive clicks into place.
6. Replace the cover (see "Installing the cover" on page 51).
7. Slide the server into the rack.
8. Connect the cables and power cords.
9. Turn on all attached devices and the server.

Removing a memory module (DIMM)

To remove a DIMM, complete the following steps.
DIMM
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 50).
4. Open the retaining clip on each end of the DIMM connector and remove the
5. If you are instructed to return the DIMM, follow all packaging instructions, and
64
IBM System x3250 M2 Types 4190, 4191 and 4194: Problem Determination and Service Guide
Drive retention clip
Alignment pins
combination drive" on page 63 to the side of the drive.
on page 47.
all external cables.
Attention: To ensure proper cooling and airflow, do not operate the server for
more than 30 minutes with the cover removed.
DIMM from the connector.
use any packaging materials for shipping that are supplied to you.
Retaining
clip