9-2] Network Data Transmission - Panasonic KX-TDA50 Programming Manual

Enhanced QSIG Call Information (Optional SD Card Required)
Enables Network Message Waiting information to be sent from the PBX to which the VPS is attached
to extensions connected to other PBXs in the network.
Default
Enable
Value Range
Disable, Enable
Maintenance Console Location
2.15.1 [9-1] TIE Table
Programming Manual References
None
Feature Manual References
1.13.13 Private Network Features—Centralized Voice Mail

2.15.2 [9-2] Network Data Transmission

Settings related to the transmission of extension BLF (Busy Line Field) data or Message Waiting
notifications over a network of PBXs can be programmed.
Extension BLF data is used to show the status of a monitored extension attached to another PBX on
a Network DSS (NDSS) button. Network Message Waiting notifications are used for the Centralized
VM feature, and a VPS can send notifications to extensions connected to any PBX in the network.
Network BLF Data Transmission for Centralised Operator Feature—Network
PBX ID
Specifies the Network ID of the PBX, for Network Direct Station Selection (NDSS). This parameter
must be set in correspondence with the Network IDs assigned to other PBXs in the network.
Network IDs 1-8 can only be assigned to one PBX each within a network. Assigning the same
Network ID to two PBXs will cause network data transmission problems.
Changing this value in Interactive mode will automatically clear any NDSS Link Data.
Default
0
Value Range
0: The PBX retransmits BLF data sent by other PBXs.
1: The PBX receives BLF data sent by other PBXs.
2–8: The PBX transmits BLF data over the network.
Maintenance Console Location
2.15.2 [9-2] Network Data Transmission
2.15 [9] Private Network
PC Programming Manual 589