Tool-Screen Customize-User Level/Administrator Level; Tool-System Data Convert (Kx-Tda50/Kx-Tda100/Kx-Tda200 Only) - Panasonic KX-TDA50 Programming Manual

This option is only available at Installer level.
It is possible to change the codes used for your level and below, but not codes used for higher levels.
Only codes that you can change will be displayed in the Programmer Code Change menu. For an
explanation of the Programmer Code levels, see 2.1.2 Access Levels.
The current code is displayed when the Programmer Code Change window opens.
The required length of each level's code is as follows:
Access Level
User
Administrator
Installer
To change a code
1.
From the Tool menu, select Programmer Code Change.
2.
Enter the new Programmer Code in the first box.
Make sure that the new code is the required length, and contains only ASCII characters.
3.
Re-enter the same code in the second box.
4.
Click OK to activate the new code.
2.4.7 Tool—Screen Customize—User Level/Administrator Level
Allows you to specify which menu screens, tools and utilities can be accessed in User and
Administrator levels.
This option is only available at Installer level.
Selected check boxes will be displayed on the main screen of the Maintenance Console and in the
menu bar to users with the level of access being edited.
To modify displayed screens
1.
From the Tool menu, point to Screen Customize, and then click the access level to modify.
2.
Select the items that you want to have displayed.
• Clear the check box beside the names of items you do not want to have displayed.
• Select the check box beside the names of items you want to have displayed.
3.
Click OK.
2.4.8 Tool—System data Convert (KX-TDA50/KX-TDA100/KX-
TDA200 only)
Converts system data (DSYS/DSSYS) files created with a previous version of the Maintenance
Console for use with the currently loaded version.
This option is only available when the Maintenance Console is in Initial mode.
It is necessary to convert system data to use it with a version of the Maintenance Console other than
the version that saved that data. This is because each new version of the Maintenance Console adds
new options and settings that are not saved by older versions.
Programmer Code Length
0 – 16 characters
4 – 16 characters
4 – 16 characters
2.4 Tool
PC Programming Manual 41